Turbo 350 4x4 transmission free#

Large oak or hardwood blocks also make excellent support fixtures. There is no such thing as too much support. Always support the vehicle with a good set of floor jacks once it is raised into position for transmission removal.

Accordingly, I added an extension to the transmission jack.Įven if a lift is not available, you can still do some things to make the job easier and safer. Large trucks and four-wheel-drive vehicles with additional ground clearance may require more height capabilities.

It is best to leave two bolts in place on one end of the pan or the other, and allow it to tilt downward to drain most of the fluid from it. If the transmission is not equipped with a drain plug, just remove the transmission pan to drain it. I had to modify one truss in the shop for cab clearance when lifting larger vehicles, even though I had 131⁄2 feet of clearance under the trusses. It takes a lot of clearance to lift up large trucks and SUVs. The jack holds it in place for hours and allows the transmission to be lowered slowly to get past obstacles. If the engine isn’t effectively supported, it can lean back and break the distributor cap in extreme cases it will bend or break the housing!Ī transmission jack is essential when using a lift. Here’s a common problem with some vehicles that have a rearlocated distributor. They require much less clearance than a hydraulic bottle jack and have plenty of capacity to hold an engine in place while the transmission is removed. Screw jacks are in the spare tire area of nearly every car sold in the past several decades, which makes them readily available at most salvage yards. The wood 4 x 4 is actually attached to the flat plate on the floor jack with 1/4-inch lag bolts so it does not slip.Ī screw jack can be used as an engine support if your shop’s lift has a movable center-jacking beam. If a suitable engine support that goes across the shock towers is not available, this is a nice option for front-wheel-drive transmissions. Although it appears a bit crude, it is an excellent engine support. This necessitates some support for the engine.Īnother option is to make an engine support from a piece of 4 x 4 and use a floor jack to raise or lower it. Some applications also require that the exhaust system behind the manifold or headers be removed to have sufficient clearance. In most cases the vehicle’s exhaust system effectively supports the engine, but it can still tilt back a little. This supports the engine when the transmission is removed. I have raised the vehicle slightly and lowered the engine oil pan onto a couple of blocks of wood. I still remember the days of doing these jobs on my back in my driveway! The lift was one of the best purchases I ever made I can’t believe that I worked for so many years without one. The lift provides a stable support and you can stand under it. Having the vehicle on a lift makes transmission removal and installation much easier. I have removed more transmissions the hard way rather than the easy way. Even so, for most of my adult life I did not have a lift in my garage or shop. It’s simply easier to stand under the vehicle to work rather than lying under it with the vehicle raised by a floor jack and supported on jack stands or on a set of car ramps. You can copy and paste this link to share: Ī vehicle lift makes transmission removal and installation much easier.

Turbo 350 4x4 transmission free#

SHARE THIS ARTICLE: Please feel free to share this article on Facebook, in Forums, or with any Clubs you participate in.